Coming soon

Cooler Hardware. Zero Liquid.

PolarBlast™ PC cooling hardware brings a new way to cool high-wattage graphics cards and workstation components. No water inside your PC, no teardown, no voided warranty. Coming to Kickstarter soon.

Expected results: high-wattage GPU under sustained load*
Expected results: high-wattage GPU under sustained load* (Throttle zone at 100°C)
Configuration GPU core Rear memory Change vs. Typical stock GPU*
Typical stock GPU* 83°C 108°C Baseline
PolarBlast™ Standard (target*) 68°C 82°C −15°C core · −26°C memory
PolarBlast™ Enhanced (target*) 65°C 78°C −18°C core · −30°C memory

*Representative stock baseline for a heat-soaked 350W+ GPU and PolarBlast™ engineering targets based on thermal simulation. Physical hardware testing is underway; measured benchmark results will be published at launch.

The problem

The back of your card is cooking

On high-wattage GPUs, the memory chips on the back of the board can pass 100°C and force the card to slow down.

Stacked GPUs breathe each other's heat

In multi-GPU builds, the top card pulls in the hot exhaust of the card below it.

Liquid cooling has trade-offs

Hours of teardown, leak risk over expensive hardware, and the rear memory often still goes uncooled.

A few spoilers

Zero liquid inside your PC

Installs in about a minute

No teardown. Factory warranty intact.

Up to 20–30°C cooler rear memory*

Built for sustained heavy loads

Engineered to keep your hardware and workspace comfortable during multi-hour compute runs.

*Engineering target based on simulation. Physical testing is underway; measured results will be published at launch.

Built for

Creator PCs with high-wattage GPUs, multi-GPU AI workstations, and high-density compute nodes.